-

How to change time on KTM Duke 200, 390, RC200, RC390(old model)






  • Press the MODE button briefly until ODO appears on the display
  • Press the MODE and SET button for 5 - 10 sec.
  • The time display begins to flash.
  • Set the hours using the MODE button
  • Set the minutes dispaly using the SET button.
  • Press the MODE and SET buttons 5 - 10 sec
  • Time is set

How to change the RPM1 and RPM2 in 200, 390, RC200, RC390(old model)


  • Press the MODE button till the Trip 2 is selected.
  • Press and hold the SET button till you see the RPM 2 on the the screen.
  • Press MODE/SET to increase or decrease the RPM2 and after it is set leave it idle for 10 seconds.
  • Now the RPM2 reading will disappear from the screen. 
  • Switch OFF and switch ON the ignition to save the changes.
  • For RPM 1 being on Trip 2, press and hold the MODE button and repeat the same above given steps.

Condition:
  • The ignition is on.
  • The bike is stationary.

Comments

Post a Comment

Popular posts from this blog

Train Simulator 2015 not working! Keeps crashing, with dump file..Fix!!!

-
Image
Train Simulator 2015 crashed at start and also creates a dump file. I followed these steps to fix this. Right click on the TS2015.exe and click Properties. And on the "Compatibility" tab change the compatibility mode to "Windows XP(Service Pack 3). And select the checkbox of "Override high DPI scaling behavior" and "Run this program as an administrator" as shown on the above screenshot. I hope it will work fine now. Make sure you are using the right crack for the game. To Download crack: :  http://www.mediafire.com/file/v1zkj0bqj46cybs/-C-Train+simulator+2015+By+MinecraftWassim.rar#!
Read more

Leaking of Engine oil is a common issue found on KTM Duke.

-
Image
Its been two years since i bought the KTM Duke 200, recently while i was cleaning my duke 200 i found some oil stains over the engine casing and i came to know that its a engine oil leak. I have heard many times that engine oil leak is a common problem on the KTM Duke. If not found the engine might seize, luckily i found it and had it serviced at KTM service center. While water washing i saw the greasy stains over the engine. I got it serviced and they refilled it with new Motul Synthetic Engine oil  and replaced the oil and air filter. They sealed the engine casing and as of now i dont see any leaking. Already my bike was due for service and at the same time the engine oil leak also happened. It costed Rs 800 for Synthetuc engine oil and Rs 750 for servicing the vehicle. And they replaced few other parts like oil filter, air filter and brake pads so totally it was around Rs 3.5K. Took the below pic after the servicing the bike.
Read more